Skip to content

Name Clicker Generator

3 credits

Type a name and get a keychain clicker with one cap per letter, each on a standard mechanical keyboard switch (cross stem) in one printed base.

Type a name

One cap per letter, up to 10. Letters A–Z, numbers 0–9, spaces (a blank cap) and the symbols below.

Font

Font

Symbols look the same in every font.

Base pattern

Base pattern

A raised texture round the base's sides. Prints upright with no supports.

Free fit test — check your switch first. One cap ("A") and a one-cell base with the same switch pocket. Print the base upright and the caps face up — no supports needed.

Colours

Base colour · Black
Letter colour · White
Cap colour · Red

You need one normal-height cross-stem keyboard switch per cap (low-profile switches won't fit). Cut off the switch's 2 metal pins before fitting.

How to put it together: 1) Cut both metal pins of each switch off flush — keep the plastic centre post. 2) Press a switch into each cell of the base until it clicks. 3) Push each cap onto its switch stem.

Each cap adds about 21.4 mm: up to 7 caps fit a 180 mm bed; 8–10 caps (10 caps ≈ 225 mm) need a 256 mm bed.

Creating your model…

Your model will be ready in a moment

3MF Recommended

Works in all modern slicers.

STL

The classic 3D printing format.

Print the base upright and the caps face up — no supports needed.

Safety note: Small items can be a choking hazard. Not a toy — keep away from young children.

Re-downloads are free.